Hardwood & engineered flooring · 2 min read

Full Glue-Down Engineered Hardwood on Concrete

When there is concrete under the floor, as in most basements and condo units, engineered hardwood can be fully glued to the slab. Every plank is bonded to the concrete with flooring adhesive, which gives a solid, quiet floor with very little height added.

Full glue-down engineered hardwood installation in a basement
Full glue-down engineered hardwood installation in a basement

Why engineered and not solid hardwood

Engineered planks have a real wood top layer over a stable cross-ply core. They move far less than solid wood when humidity changes, which makes them suitable for gluing on concrete and for basements. Solid hardwood is normally not glued to a basement slab.

Moisture testing comes first

Concrete holds moisture, especially below grade and in newer buildings. Before installation the slab is tested, and the adhesive is chosen to match the readings. Many modern urethane and silane adhesives also act as a moisture barrier when applied at the right thickness.

Glue-down herringbone hardwood being laid over concrete
Glue-down herringbone hardwood being laid over concrete

Flat matters more than level

Glue-down flooring follows the slab, so dips and humps show through as hollow spots and uneven seams. High spots are ground down and low spots are filled with a patch or self-levelling compound until the slab is within the manufacturer's flatness tolerance.

Laying the floor

The adhesive is spread with the notched trowel the manufacturer specifies, and planks are set into it a section at a time. Boards are pressed and weighted where needed so the adhesive makes full contact. Plank direction can change between rooms and hallways when the layout calls for it.

Basement hallway overview showing the change in plank direction in full glue-down engineered hardwood
Basement hallway overview showing the change in plank direction in full glue-down engineered hardwood

After installation

Light foot traffic is usually fine the same day. Heavy furniture and appliances wait until the adhesive has cured, typically 24 to 48 hours depending on the product.

Common questions

Can you put hardwood in a basement?

Engineered hardwood can be installed in a dry basement when the slab passes moisture testing. It is glued down or floated over a suitable underlay. Solid hardwood is not recommended directly on a basement slab.

Is glue-down hardwood noisy?

No. Because it is bonded to the slab, it sounds and feels solid underfoot, with no hollow echo.

Can glue-down engineered hardwood be refinished later?

Yes, if the wear layer is thick enough. Many engineered floors can be sanded and refinished at least once.

Planning this for your home?

Send your city, rough measurements and a few photos. We will tell you which method suits your floor or stairs and give you an estimate after a visit.

Our Services

Related services.

Keep Reading

More guides.

All guides
Call 416-786-1087Get a quote