Common problems we repair
Deep scratches and dents from furniture, pet damage, boards lifted by a leak, burns, cracked boards near doorways, loose or squeaky areas, and gaps around old repairs that were not done properly.


Replacing boards without tearing out the floor
Damaged boards are cut out carefully without disturbing their neighbours. New boards are woven into the existing pattern so the end joints stay staggered, and they are glued and fastened like the original floor.

Matching the wood
We match species, width, thickness and colour. Spare boards left from the original installation are the best match, so tell us if you have any in the garage or basement.
After a leak
Water-damaged floors are only repaired after the source of the leak is fixed and the subfloor has dried. Moisture readings tell us when it is safe to install new wood.
Blending the repair
Sun and age change the colour of wood. Sometimes the best result is to sand and refinish the whole room after the repair, so every board has the same colour and sheen. We sand with dust extractors to keep the home clean.
Common questions
Can you fix a few boards instead of replacing the whole floor?
Yes, in most cases. We check how far the damage goes first.
Will the new boards match?
We get as close as possible. Refinishing the room afterwards gives the most even result.
Do you repair floors you did not install?
Yes. Many of our repair clients had their floors installed by someone else.
Planning this for your home?
Send your city, rough measurements and a few photos. We will tell you which method suits your floor or stairs and give you an estimate after a visit.


